08 ski doo summit 800 R rebuild


Moderator: john

Post Reply
Posts: 3
Joined: Wed Nov 14, 2012 6:31 pm

08 ski doo summit 800 R rebuild

#1 Post by Bigdan11 » Wed Nov 14, 2012 6:38 pm

i had to take apart my engine to replace the cylinder walls and replace a piston is there anything i have to do when i put it back together, like oil in the bottom of the crank case or anything special that i have to do and watch out for?

User avatar
Posts: 198
Joined: Tue Dec 20, 2005 5:42 pm

Re: 08 ski doo summit 800 R rebuild

#2 Post by Summit800 » Fri Nov 16, 2012 4:30 pm

I would look at the Isoflex Grease in the Crank Bearings, perfect time to add if needed, Aside from that, I always like to lube the rod bearings and wrist pins with a little 2 stroke oil as pre lube.
Dont forget to lift the rear and then the front to get all the air out of the cooling system before you start her up.
And a little premix in the fuel for the first tank after rebuild.

Post Reply